Every project below was designed, installed, or serviced by our crew. Browse real installations with system specifications, surface sizes, and the neighborhoods they serve.
A recent installation that shows the full range of what a properly designed heated surface system can do.
A 1960s Minneapolis home with a steep driveway and a north-facing front walkway that held ice well into March. We designed a combined hydronic and electric system to solve both problems in a single project.
Filter by system type to see the projects most relevant to your property.
Full tear-out and replacement of a cracked 1980s concrete driveway with an embedded hydronic system. Zoned for tire path and apron separately.
A Highland Park home with four entry steps that routinely iced over. We added electric heating mats under new pavers and high-density cable on the steps.
A large garage apron that collected plow banks every winter. Hydronic system runs from the home's existing high-capacity boiler with a dedicated zone.
A client's hydronic system stopped working mid-January. We diagnosed a failed circulator pump and cracked heat exchanger, then replaced the boiler in 48 hours.
Existing concrete was sound and thick enough to support thin-profile electric mats under a new topping layer. No demolition, no disposal fees.
Integrated into a custom home build from the foundation stage. Tubing was laid before the slab pour, with the boiler installed in a dedicated mechanical room.
A long side sidewalk that froze solid each winter. Full electric heating coverage from the front gate to the porch landing, with separate zone control.
A single zone in a ten-year-old electric driveway stopped heating. We located the fault with thermal imaging and repaired the section without replacing the whole mat.
A wide turnaround area where a plow could not maneuver without damaging landscaping. Hydronic system keeps the entire pad clear without equipment.
A solid asphalt driveway that could not be torn out. We cut narrow channels, routed hydronic tubing, and sealed with a hot-pour overlay system.
A steep north-facing driveway that refroze every night after daytime melt. We added slope-aware zoning and a channel drain to solve the refreeze problem.
Scheduled pre-season service on a five-year-old hydronic system. Full glycol flush, freeze-point verification, and boiler tune-up before winter.
Book a free inspection and we will design a system tailored to your driveway, walkway, or parking pad.
Book Free Inspection →